User's Manual

interfaces.”
start_ap, 4, “Start AP mode.”
stop_ap, 0, “Stop AP mode.”
wifi_on, 0, “Turn WiFi device on.”
wifi_off, 0, “Turn WiFi device off.”
wifi_reset, 0, “Reset the WiFi device.”
antenna, 1, “Antenna selection. 3 = Auto”
set_country, 1,
“<country code>”
“Set country.”
RW8200 COMMAND Detail
1. ? 0, "Help menu"
(prompt)?
2. help 0, "Help menu"
(prompt)HELP
>
console Commands:
help [<command> [<example_num>]]
- Print help message or command example.
dhcp
- Perform DHCP as a client to obtain an IP address.
get_mac_addr
- Get the device MAC address
get_rssi
- Get the received signal strength of the AP (client mode only)
join <ssid> <open|wpa|wpa2> [key] [ip netmask gateway]
- Join an AP. DHCP assumed if no IP address provided
join_specific <ssid> <bssid> <channel> <open|wpa|wpa2> <key> [ip
netmask gateway]
- Join a specific AP. DHCP assumed if no IP address provided
leave
- Leave an AP.
Powersave <1|0>
- Enable/Disable powersave mode.
scan
- Scan all enabled channels and print a list of APs found.
set_ip <ip> <network> <gateway>
-Set a static IP.
set_tx_power <0-32>
- Set the tx power in dBm.
get_tx_power
- Gets the rx power in dBm.
status
- Print status of the Wi-Fi and network interfaces.
start_ap <ssid> <open|wpa|wpa2> <key> <channel>
- Start AP mode
stop_ap
Stop AP mode
wifi_on
- Turn Wi-Fi device on.
26