Specifications

2. Once connected to the console Menu System, either by telnet or by a serial connection the interaction

should be same in either case. In order to configure the V4410 unit’s IP settings you will want to go

to the Configuration Submenu

3. From the Configuration Submenu you will want to modify options 4-7. Once these options have been

set to the desired values, you should invoke configuration Submenu item#12 (Save) which will store

the new settings into the flash, so they will be stores across a reboot. After saving your changes go up

to the top-level menu (99 to go up), and then issue a reset from the top-level menu. The V4410 unit

should reset and the Menu should appear on your console window again when the reboot is complete,

and your V4410 should be ready to test.