User's Manual

2) The reading is out of lower limit (-50C/-58F)
2) Keep the measurement above lower limit
HH.H
1) Sensor short circuit
2) The reading is out of upper limit (70C/158F)
1) Return the thermometer for repair
2) Keep the measurement below upper limit
con
Receiver is searching the signal from the transmitter
1) Turn on the transmitter
2) No action required (searching when start up)
Syn
Code rematch
No action required
FAI
Connection fails
Make sure within a valid distance range
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. This device complies with Industry Canada
Licence-exempt RSSs. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicable aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de
l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Changes or Modifications not expressly approved by the party responsible could void the user’s authority to operate this device.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
TRANSMITTER FCC ID: 2AI67-806R / IC: 22116-806R
MARK WU
2019/7/24