User Manual

COMPONENTS
1 4
2 5
3
Body
STRIPPING DIMENSIONS
Slide the back nut onto the cable.
Strip the cable.
Cut 2 slots in the jacket if necessary.
Slide the clamp braid sleeve between the cable dielectric
and the braid.
Mount the gasket into the body.
Screw sub-assembly into the connector body with the adapted
w
rench.
Recommended coupling torque ( see connector TDS ).
6
Clamp 01 : Small cables
Cut the braid flush with the clamp braid sleeve.
Slide the spacer onto the cable.
Slide the centre contact on until it bottoms against the cable
dielectric.
Solder the centre contact onto the inner conductor.
Slide the back nut over the cable assembly.
Centre contact
Back nut
Insulator
Gasket
Clamp braid
2
1
2
3
1
2
1
1
1
1
RF interconnect solutions
a
b
c
d
e