Owner`s manual

True to the Music
Radial Engineering Loopbone Owner’s Manual
12
Q: Can the Loopbone be used as an ABY for my amp?
A: No, not really. To properly and safely perform ABY switching, one
should have isolated outputs such as is found on the Radial Switchbone
and the Radial JD7. Keep in mind that amplifiers can often be floating
several hundred volts around their circuitry and if not connected prop-
erly, can lead to an electric shock. The Loopbone’s output, in theory,
could be connected to two amplifiers and perform switching, but we would
recommend that you have a qualified technician on hand to ensure that
the amps are properly grounded and the connection is safe.
Q: Can I use the tuner output to drive an amplifier or another effect
device?
A: No. Once again, you should have an isolated output if you intend to
drive more than one amp at a time. Also, considering that the tuner
output is on all the time, it is unlikely to provide you with any realizable
benefit that could not be structured using the Loopbone as it was de-
signed.
Q: Is there a way to set the Loopbone up so that it can mute for
tuning?
A: Yes. All you do is insert a simple on-off mechanical footswitch in one
of the loops and when you want to tune, hit the switch before you acti-
vate the loop. This will eliminate any contact switch noise from the me-
chanical switch. When the song stops, hit the loop and your signal will
be muted and allow you to quietly tune.
Q: Will the Slingshot work on all amplifiers?
A: In all likelihood the answer is yes. Most traditional style amplifiers will
work with the Slingshot but there are surely some amp designs that do
not follow convention. If you are not sure, consult your Tonebone dealer
or have a technician look at your amp to see if it can be made to be
compatible.
Q: How do I know if my amp will be Slingshot compatible?
A: If your amp employs a basic footswitch with a ¼” or ¼” TRS, it will in
all likelihood be compatible. If it employs some type of multi-pin connec-
tor or telephone style jack, it may not. Consult you dealer or amp manu-
facturer for advice on how you can make an adaptor that will allow you to
enjoy the benefits of the Loopbone’s Slingshot.
Q: Can I use another power supply other than the 15VDC that comes
with the Loopbone?
A: No. Never use another power supply unit other than the one included
with your Loopbone. Because of the Loopbone’s Class-A circuit, a more
powerful 15VDC supply is required. If you need a replacement power
supply, contact your Tonebone dealer.