User guide

7. SET-UPS

The Radial Switchbone has been designed for maximum ﬂexibility on

pedal boards or as a stand alone ampliﬁer switcher / controller. As

such, the Switchbone can be positioned at the input of the signal chain,

the output or in between. Where you use the Switchbone is entirely

based on how you intend to use it. As such, the combinations are truly

endless and the only way to truly approach the subject and bring value

to you the player is by discussing options and a philosophical approach

to creating your sound. (Of course all the while having fun!)

Take a moment to consider how the boost circuit will work within a

given set-up. For instance, if you are using an ampliﬁer that is dis-

torted, the boost will not increase perceived loudness but increase the

saturation or distortion. This would for instance, add greater sustain

during a solo.

Activating the BOOST with a clean ampliﬁer will on the other hand in-

crease the loudness. Therefore if one were to use the Switchbone after

a distortion pedal, one could get a boost for soloing. Used in front of a

distortion pedal would once again yield more saturation.

As shown here, the Switchbone can be used in countless conﬁgura-

tions based on how your guitar amps are designed, the type of sounds

you are looking for and what effect pedals you use. Ultimately, it will

open the door for new sounds and combinations never before realized.

Radial Engineering Switchbone Owner’s Manual

True to the Music True to the Music