User Manual

Radial Engineering Ltd.

X-AMP Reamper™

True to the Music

FEATURE SET: OUTPUT PANEL

8. LEVEL CONTROL: The output LEVEL control sets the volume level

going to the guitar ampliﬁ ers. This potentiometer is recessed to

prevent accidental change and is adjusted using a guitar pick or ﬂ at-

head screwdriver.

9. CLIP LED INDICATOR: To ensure the signal from the mixer or

recorder does not overload the X-Amp, a clip indicator on the front

panel provides clear viewing. If this LED illuminates, reduce the signal

level.

10. DIRECT OUT-1: This ¼” output connects to guitar amp-1. This is a

transformerless, direct-coupled output and is used to connect to your

primary guitar ampliﬁ er. This provides the primary ground path for the

X-Amp. This output must always be connected to a properly grounded

ampliﬁ er.

11. POLARITY 180º: The polarity reverse works with the transformer-

coupled OUT-2 ¼” output jack. This ﬂ ips the polarity of the output to

allow two ampliﬁ ers to play ‘in-phase’.

12. ISOLATED OUT-2: This ¼” transformer isolated output connects to

your second ampliﬁ er. Transformer isolation allows use of two amps

without introducing hum and buzz caused by ground loops.

13. GROUND LIFT OUT-2 (located on side): This recessed switch gives

you the option to bypass the transformer isolation and convert the

OUT-2 into a direct and grounded output. It is factory set to LIFTED

(inward position) to provide a safe and noise free connection to

ampliﬁ ers. See page 9 for more information about using this feature.

10 11 12