User Manual

Made in Canada15VDC · 400mA
INPUT
OUTPUT
LEVEL
HIGH
DRIVE
LOW
TOP END
BRIGHT
FLAT
DARK OUT
®
DISTORTION
CONTOUR
MID BOOSTVOICING
FAT 12dB
NOTCH 7dB
OUT
®
1
2
3
4
5
6
7
8
9
DRIVE control: Used to adjust overall amount of input gain &
distortion. For even more drive, use the GAIN switch.
MID BOOST switch: This gives you +7dB & +12dB @ 360Hz.
This allows the guitar to cut through the mix and is especially useful
for soloing.
CONTOUR control: Adjust balance of low & high frequencies in the
“NOTCH” & “FAT” VOICING mode. Hint: start at 12 o’clock position
VOICING switch: In NOTCH position: passive boost coloration of
low’s & high’s in FAT position: passive midrange tight filter.
LOW control: Active ‘post-distortion’ tone control. Boost or cut
±14.5dB @ 100 Hz from 12 o’clock position.
TOP END switch: BRIGHT = +6dB @ 10KHz; FLAT is the
Recommended position when the amp’s bright switch is on. DARK =
6dB @ 3.3KHz; normally used with super bright inputs.
HIGH control: Active ‘post-distortion’ tone control. Boost or cut
±10dB @ 4.3KHz from 12 o’clock position.
LEVEL control: This is used to adjust the output level without
altering any of the tonal characteristics.
Foot-switch: True-Bypass type; i.e.: when the Tonebone is off,
the signal passes straight through without any effect. An on/off
status indicator LED is provided.
6. Tonebone Hot British Function Overview
4