User manual

Radial Engineering Ltd.
DiNET DAN-TX™
True to the Music True to the Music
® ®
Radial Engineering Ltd.
DiNET DAN-TX™
3
FEATURES
1 2 3 4
1. ¼” INPUTS: Stereo inputs accommodate both balanced (TRS)
and unbalanced (TS) connectors for use with instruments or
professional +4dBu sources. When LINE/INST switch is set to INST,
LEFT becomes a mono input and RIGHT becomes a thru-put for
connection to an ampli er.
2. RCA INPUTS: Provided for connection to CD/DVD players and
other consumer level playback devices. Wired in parallel with the
¼” and 3.5mm inputs.
3. 3.5mm INPUT: Stereo TRS input for use with laptops, tablets and
phones. Wired in parallel with the ¼” and RCA inputs.
4. TRIM: Adjustable trim control to set input levels. Provides -10dB of
cut or +10db of gain at the min/max settings.
5. LINE/INST: Used to select between line
level or instrument level inputs. When
set to INST the ¼” stereo inputs are
recon gured as a mono instrument input
with a thru output.
6. PAD: Enables a -18dB input pad for high
output line level sources.
7. HPF: Enables a high pass  lter to roll off
frequencies below 80Hz.
5 6 7
4
8 9 10 11 12 13 14
8. +15V LED: Will illuminate when the DAN-TX is connected to
the included DC power adapter. A cable lock is provided to
prevent accidental power loss.
9. POWER: 15VDC connection for use with included Radial
power adapter when PoE is not available.
10. PoE LED: Will illuminate when the DAN-TX is receiving
power over Ethernet (PoE).
11. SIG/CLIP LEDs: Will illuminate when input signal is detected.
LED color will change to red at -6dBfs.
12. SYNC LED: Red LED is illuminated when unit is powered.
Green LED will illuminate once connected to an Ethernet
network. Flashing green LED indicates that the DAN-TX is
in master clock mode, solid green LED indicates that it is in
slave mode.
13. SYS LED: Red LED illuminates when power is  rst applied.
Switches to green LED once Dante processor becomes
active.
14. ETHERNET: Used to connect to the Dante enabled network
via CAT5e or CAT6 cable.