www.radialeng.com ® True to the Music™ DAN-TX ™ 2-Chan Dante ® Transmitter User Guide Radial Engineering Ltd. 1588 Kebet Way, Port Coquitlam British Columbia, Canada, V3C 5M5 Tel: 604-942-1001 • Fax: 604-942-1010 Email: info@radialeng.
Note: This device has been tested and found to comply with the limits for a Class A digital device, according to Part 15 of the FCC Rules and EN55022. These limits are designed to provide reasonable protection against harmful interference when the device is operated in a commercial environment. This device generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the user manual, may cause harmful interference to radio communications.
True to the Music ® True to the Music ® oVerVieW The DiNET DAN-TX is an analog to digital converter that is designed to take the signal from instruments or line level audio sources and transmit them over an existing Dante-enabled network. A typical direct box is a device that converts an unbalanced highimpedance instrument or consumer line level audio output to a balanced low-impedance signal that can easily interface with a professional audio system.
True to the Music ® True to the Music ® feaTUreS 1 2 3 4 8 9 10 11 12 13 14 ¼” inPUTS: Stereo inputs accommodate both balanced (TRS) and unbalanced (TS) connectors for use with instruments or professional +4dBu sources. When LINE/INST switch is set to INST, LEFT becomes a mono input and RIGHT becomes a thru-put for connection to an amplifier. 8. +15V leD: Will illuminate when the DAN-TX is connected to the included DC power adapter.
True to the Music ® geTTing STarTeD True to the Music ® Start with the TRIM control at 12 o’clock and adjust the level as needed, turning up if you require more signal, or down if the Left SIG/CLIP LED indicator turns red. The TRIM control will not affect the signal level from the THRU output. The PAD will also not affect the ¼” connections when the DAN-TX is set to INST mode. To clean up excessive low frequency content, engage the HPF on the side of the DAN-TX to roll off frequencies below 80Hz.
True to the Music ® True to the Music ® Dan-TX WiTH UnBalanCeD ConSUmer aUDio Dan-TX WiTH ProfeSSional line-leVel eQUiPmenT When using the DAN-TX with consumer audio devices, typically either the RCA connectors or the mini 3.5mm connector will be used, however, the ¼” inputs can also be employed. With the LINE/INST switch set to LINE, the DAN-TX will accept consumer line level signals such as those from a CD player, laptop, tablet, or smartphone.
True to the Music ® Specifications* CPU/ CODEC CPU/ CODEC METER SENSE METER SENSE HP FILTER HP FILTER DANTE ETHERNET PHY Block Diagram* True to the Music ® BAL AMP LINE/INST 20dB INPUT TRIM AMP 20dB INPUT TRIM AMP Features Input Connectors:................................................................ 2x 1/4” TS/TRS, 3.5mm TRS, 2x RCA Output Connectors:............................................................. RJ45 Ethernet LED Indicators:...............................................
True to the Music ® Notes Radial Engineering Ltd. True to the Music ® Notes 11 DiNET DAN-TX™ Radial Engineering Ltd.
THREE YEAR TRANSFERABLE LIMITED WARRANTY RADIAL ENGINEERING LTD. (“Radial”) warrants this product to be free from defects in material and workmanship and will remedy any such defects free of charge according to the terms of this warranty. Radial will repair or replace (at its option) any defective component(s) of this product (excluding finish and wear and tear on components under normal use) for a period of three (3) years from the original date of purchase.
