User manual

Radial Engineering Ltd.
DiNET DAN-RX™
True to the Music True to the Music
® ®
Radial Engineering Ltd.
DiNET DAN-RX™
5
MAKING CONNECTIONS
Connect two standard low-impedance XLR cables from the LEFT and
RIGHT outputs to the inputs of your PA or recording system. These XLR
outputs conform to the AES standard and are balanced to drive long
cable runs up to 100 meters (300’) without noise, and are suitable for
connecting the DAN-RX to professional mixing consoles, preamps and
power ampli ers. The signal level at these outputs is controlled by the
audio playback source.
IMPORTANT NOTE: The DAN-RX does not require phantom power to
operate. The DAN-RX is equipped with blocking capacitors to prevent
damage from DC voltage, but for best results please ensure that the
phantom power is switched off when connecting to the microphone
input of a mixer.
Left
Right
Audio connections for PA system and recording systems use
balanced XLR cables up to 100 meters (300’).
6
USING THE HEADPHONE AMPLIFIER
The DAN-RX is equipped with a dedicated stereo headphone output. The
3.5mm (1/8”) output is designed for both ear buds and standard TRS
stereo headphones wired tip-left, ring-right and the sleeve is ground. The
volume control on the DAN-RX affects the headphone output only, as it
is designed for testing purposes rather than setting the level of the XLR
outputs.
Be careful! The DAN-RX is designed for professional use. The headphone
ampli er is very powerful and is capable of high sound levels that could
damage your hearing. Always ensure the volume control is set to its
lowest point (fully counter-clockwise) when plugging in headphones, and
slowly increase the level to a satisfactory level. If no signal is present,
ensure that audio is routed to the unit via the Dante Controller software.
Not all headphones are created equally! Always start at the lowest
volume when switching headphones. While the DAN-RX is designed
to work with headphones of all different impedances, volume level can
change drastically from pair to pair.
Headphone Safety Warning
Caution: Very Loud Amplifi er
As with all products capable of producing high sound pressure levels (SPL), users
must be very careful to avoid the hearing damage that may occur from prolonged
exposure. This is particularly important when applied to headphones, as prolonged
listening at high SPL’s will eventually cause tinnitus and can lead to partial or complete
loss of hearing. Please be aware of the recommended exposure limits within your
jurisdiction and follow them closely. The user agrees that Radial Engineering Ltd is
not liable for any health effects resulting from the use of this product and the user
clearly understands that he or she is entirely responsible for the safe and proper use
of this product. Please consult the Radial Limited Warranty for further details.