User manual

Radial Engineering Ltd.

DiNET DAN-RX™

True to the Music True to the Music

® ®

Radial Engineering Ltd.

DiNET DAN-RX™

1 2

FEATURES

2 3

7 8 10

1. HEADPHONE: Sets output level of the headphone ampli er. Mini

3.5mm (1/8”) TRS headphone output. Works with earbuds and

standard headphones.

2. SYNC LEDs: Red LED is illuminated when unit is powered. Green

LED will illuminate once connected to an Ethernet network. Flashing

green LED indicates that the DAN-RX is in master clock mode, solid

green LED indicates that it is in slave mode.

3. ETHERNET PORT: Connects to the Dante network via standard

CAT5e or CAT6 Ethernet cable. This port delivers the digital audio

signal from the network and powers the DAN-RX when Power over

Ethernet (PoE) is available.

4. SYS LEDs: Red LED illuminates when power is  rst applied.

Switches to green LED once Dante processor becomes active.

5. +15V LED: Will illuminate

when the DAN-RX is receiving

power via the included DC

power adapter.

6. PoE LED: Will illuminate when

the DAN-RX is receiving Power

over Ethernet (PoE).

5 6

7. LEFT AND RIGHT XLR OUT: Balanced analog audio outputs.

Output level is controlled by audio playback source.

8. POWER: 15VDC connection for use with included Radial power

adapter.

9. CABLE CLAMP: Used to secure the power supply cable (when

used) to prevent accidental disconnection.

10. NO SLIP PAD: Provides electrical and mechanical isolation and

keeps the DAN-RX from sliding around.

11. GROUND LIFT: Lifts pin-1 on

both XLR outputs to eliminate

buzz and hum from ground

loops. Move the switch to the

right (towards the Ethernet

input) to lift the ground.