User manual

When the dose accumulation is switched in the field of button C in the «MEASURE»
and «SEARCH» profiles the icon «DOSE» is set, it indicates that the accumulation is being
executed.
e) Section «CALIBRATION».
The mode «CALIBRATION» should be used only by trained personnel in certified or-
ganization, when in the process of checking the product the new calibration coefficients
should be set up.
In a «CALLIBRATION» mode it is possible to set up a default settings by entering a
code < 050 >.
1.3.3.4 Output of the accumulated dose readings.
When the dose accumulation function is on, in the field of the button C in the modes
«MEASURE» and «SEARCH» the icon «DOSE» is set, it indicates that dose accumulation
is being executed.
Pressing the «DOSE» calls the screen onto the display, where the title («DOSE 1» or
«DOSE 2»), the value of the accumulated dose and the period during which the
accumulation was carried out are shown. Dose value is updated every minute.
Pressing the button «RESET», when the screen «DOSE» is indicated, clears the
accumulated dose.
Closing the screen «DOSE» is automatic, when the new evaluation data is ready, i.e.
the time of the «DOSE» indication is not permanent and may vary.
1.4 Marking and sealing
1.4.1 On the main body of the detector are shown:
¾ the trademark of the manufacturer;
¾ the trademark – RADEX.
¾ The identification marking of the product – RD1008 is displayed when you switch the
product on.
1.4.2 Serial number of the detector is displayed when you switch the detector on.
1.4.3 The manufacturer does not seal the detector.
1.5 Packaging
1.5.1 Packaging provides safety of the detector during transportation.
1.5.2 Packaging of the detector should be conducted in closed ventilated rooms at an
ambient temperature from +15 up to +40
0
C and relative humidity to 80%, out of
corrosive contaminants and dust in the environment.
► √ OFF
DOSE 1
DOSE 2
●CHANGE
RETURN ●
● ▼
DOSE 1
8,29 µSv
■ MONTHS:
12
DAYS: 8
HOURS:
12
● RESET DOSE ●
OFF
► √ DOSE 1
DOSE 2
●CHANGE
RETURN ●
● ▼
21