User manual

When the call is switched on and the threshold off the call will accompany each
registered quantum.
In the modes «MEASURE» and «SEARCH» the turned on alarm is displayed as the
icons on the display.
« » - The call is on
If you turn the call off, there is no icon.
Notes:
1) The «LOUD» call is usually switched on in noisy places or on the street.
2) In the quiet places, in the office or in an apartment we recommended you to use
«QUEIT» call with the set up threshold value.
• Option «VIBRA-CALL »
The option «VIBRA-CALL» is used to turn on and off the vibra call signal.
The control algorithm is similar to that described above the call control algorithm.
If VIBRA-CALL is on, then the registration of each of the next gamma-quantum will
switch on the vibrating alert, which signals the threshold is exceeded; when the threshold
is exceeded for beta-radiation the vibrating alert will be switched one time at the end of the
measurement cycle.
If the alarm threshold is off the vibra signal accompanies each detected gamma
quantum. Beta particles detection is accompanied by one vibra signal at the end of the
measurement cycle.
In the modes of «MEASURE» and «SEARCH» the switched on vibra signal is indi-
cated on the display as the icon - « ».
When the vibra signal is off, there is no icon.
Notes:
1) In the quiet places, office or apartment we recommend you to use the vibr a signal
with the set threshold value.
2) You should remember that the use of vibra signal greatly reduces the time of
continuous operation of the product.
• Option «DOSE».
The option «DOSE» is used for the control of the «DOSE» function: the switching on
of the accumulated dose of gamma radiation counting and the measuring of the period
during which it was accumulated, selection of one of two options «DOSE 1» or «DOSE 2»
or switching off this function. Your product provides for the accumulation and saving of the
doses for two independent users
To enable the accumulation of gamma-radiation dose it is necessary to enter the
«MENU», go to «SETTINGS», place the cursor in front of the line «DOSE» and press
«SELECT». The screen of the «DOSE» control function appears: switching the profile off
and selection of one of two possibilities of accumulation «DOSE 1» and «DOSE 2».Next,
you need to move the cursor to the desired line «DOSE 1» or «DOSE 2» and click
«CHANGE». The icon « » confirms the setting.
Exit from the control screen: double click «RETURN» to return to «MENU» and
«RETURN» to switch to «MEASURE».
When selecting one of the doses its value is accumulated and the value of the other
dose is saved. When you specify a previously saved dose, its value is added to the
previously memorized result. This option allows you to estimate the doses accumulated in
different conditions, at different time, for different people, etc.
20