Owner's Manual

PAGE 14 PAGE 15
Ka Narrow/Wide/Segmentation
1. Ka Narrow: Ka Band – 33.8Ghz +-99Mhz, 35.5Ghz+-99Mhz,
34.6Ghz thru 34.85Ghz
2. Ka Wide: All Ka band: 33.399 thru 35.700GHz
3. Ka Segmentation: This feature allows users to select, from
9 filtered settings, a customized sweep of Ka band.
a. Ka 1: 33.399 thru 33.705 Ghz On/Off
b. Ka 2: 33.705 thru 33.903 Ghz On/Off
c. Ka 3: 33.903 thru 34.191 Ghz On/Off
d. Ka 4: 34.191 thru 34.587 Ghz On/Off
e. Ka 5: 34.587 thru 34.803 Ghz On/Off
f. Ka 6: 34.803 thru 35.163 Ghz On/Off
g. Ka 7: 35.163 thru 35.379 Ghz On/Off
h. Ka 8: 35.379 thru 35.613 Ghz On/Off
i. Ka 9: 35.613 thru 35.701 Ghz On/Off
Threat Display
Threat display will show up to 3 radar bands being detected at
the same time. The display will first prioritize laser alerts, then
MRCD, Ka, K, and X (in that order).
Bogey Tone
If another frequency is detected during X, K, Ka Band Alert, DS1
sounds the Bogey Tone and then the band alert continues.
Auto Mute Mode
Auto Mute Mode: Selectable (On/Off)
1. When Radar (X, K and Ka) alert starts, DS1 alerts for
the time which set in Auto Mute Start Option (1, 2, or 3
seconds). After the Auto Mute On is triggered on the DS1,
volume will reduce by Auto Mute Vol Option Percentage.
2. Auto Mute ends 10 seconds after the alert ends. If the
same radar is detected within 10 seconds, the unit keeps
Auto Mute On.
3. Auto Mute is not applicable to Laser alert.
4. If the current volume level is 0, DS1 keeps the current
volume level.
Auto Dim Mode
DS1 has a light sensor to determine when the detector should
use the Bright settings (daylight) and when it should use the
Dim settings (nighttime). The brightness will adjust to Bright or
Dimmer, depending on the brightness of surroundings.
Auto Power Mode
1. If DS1 detects its speed is 0 or if it cannot receive GPS
location data for the set time (15 min or 30 min), the Auto
Power Off alert will ring for 10 seconds before powering off
the detector.
2. The Auto Power Off function stops if the user presses any
button during the Auto Power off alert
3. The Brightness is automatically set to Bright.
Power Cord Alert LED
1. Power Cord Alert LED turns on with the power.
2. Power Cord Alert LED blinks during laser or radar (X, K, Ka)
alerts
3. Power Cord Alert LED blinks slowly when the speed of
laser or radar (X, K, Ka) alerts beeping sound is slowing
and blinks fast when the speed of the laser or radar alert
beeping sound increases.