Owner's Manual

PAGE 12 PAGE 13
To Delete a User Point
During a User Point alert, press [MUTE] for over 2 seconds to
delete User Point.
Delete All User Points
If the user selects “Delete All User Point?” in the menu, all User
Points will be deleted.
To Delete Speed, Red Light, Speed & Red Light Camera
During a Speed Camera, Red Light Camera, Speed & Red Light
Camera Alert, press [MUTE] for over 1 second to delete the
camera alert.
Auto Lockouts
If the same signal (X Band : +-10Mhz, K Band : +-10Mhz) is
detected at the same location three times( 1st + 2nd + 3rd), DS1
will automatically lock the signal out as a false alert. Once a
signal is saved in Auto mute memory (the 1st counting) , DS1 will
not save the same signal for 8 hours even though it is detected
again, which means it takes at least 16 hours( 1st + 2nd + 3rd)
to automatically lock a signal out. The interval of 8 hours is to
avoid saving too many signals in Auto mute memory.
The DS1 can store 16,500 Auto Lockout points.
The user can set the radius using Auto Lockout and Pin Home.
If both Lockout and Auto Lockout are detected at the same
time, the display shows "Lockout" as a priority. Auto Lockout
Range
Entry : approximately 450m
Exit : approximately 500m
Delete All Auto Lockouts
If choose “Delete All Auto Lockout?” in the menu, all Auto
Lockout will be deleted
K-notch
The DS1 will mute the alert voice when K Band is within the
specified K-notch ranges. Display will turn gray and display
“K-notch” in green if K-notch display setting is on. If K-notch is
set to "Blk all signals", the DS1 will not alert for all signals within
the range. If K-notch is set to "Blk weak signals", the DS1 will not
alert for any weaker signals within the range but still alert for
stronger signals of the same frequencies.
Current K-notch ranges:
24.199 +- 0.005Ghz
24.121-24.124Ghz
City Mode
1. Auto
DS1 sets Highway or City automatically depending on the
vehicle speed. Auto mode is not activated when GPS is
disconnected. If vehicle speed is over 50mph, Highway
Mode is set, and if vehicle speed is under 50mph, City
Mode is set.
2. Custom
User can set the sensitivity of each band (50%-100%)
K Narrow/Wide
1. K Narrow: K Band : 24.080 thru 24.200GHz
2. K Wide: All K Band : 23.900 thru 24.250GHz
3. NZ K Narrow: K Band 24.000 thru 24.100GHz. This option
is only available when the DS1 is set to AUS/NZ in the
Region Menu.