Owner's Manual

PAGE 10 PAGE 11
Low Speed Mute
If the current speed is slower than the speed in Low Speed Mute
which user set, Speed Camera, User Point, Auto Lockout, X, K,
User Point Limit Speed Voice, Over Speed Warning Voice will be
Mute.
RLC Auto Mute
If the current speed is slower than the speed set by the user in
RLC Auto Mute, the alert for Red Light Camera and Red & Speed
Camera will be muted.
Lockouts
The user can mute the frequency at the specific location during
X or K band alerts. Then, if the same frequency (X, K band: +/-
10MHz) is detected at the same location, X and K alert will mute
and the display will show ‘Lockout’ in green at the lower right
corner until DS1 goes out of the 500m radius.
Lockout Range
Entry: approximately 450m
Exit: approximately 500m
If both Lockout and Auto Lockout are detected at the same
time, the display will show "Lockout."
To save a lockout
1. When X or K alerts, press [MUTE] to mute the voice and
beep alerts.
2. Press [MUTE] again to store the current location and the
frequency of the false alert. The display and voice will say
"Lockout Stored."
ADDITIONAL SETTINGS
3. If the lockout is saved properly, the display will show
"Lockout" in green in the lower right corner until the DS1 is
out of the 500m radius.
4. If the user exceeds 5000 lockouts, the oldest lockout will
be deleted and will be replaced with the newest lockout.
To Delete a Lockout
1. When the DS1 gets a lockout signal, you will see "Lockout"
in green in the bottom right corner
2. While "Lockout is still displayed, press [MUTE]. The voice
and display will say "Delete Lockout?"
3. Press [MUTE] again to delete. The voice and display will
confirm that the lockout was deleted.
If the DS1 can't save the Lockout due to an issue receiving the
GPS location, the voice will say "GPS Error."
Delete All Lockouts
Select "Delete All Lockouts" in the menu and press [MENU] to
confirm.
User Point Alert
When User point is detected, the voice announces (“User Point
Ahead”) and shows User Point display.
User Point Alert Range
Entry : approximately 450m
Exit : approximately 500m
To Save a User Point
Press [MUTE] for 2 seconds to save a User Point. When a User
Point alert is detected, User Point can not be saved. The user
can save a maximum of 500 points.