Instructions

53
EN
12. Manually changing the target temperature
If necessary you can manually change the target temperatures
of the automatic heating phases temporarily. The change is
made on the standard display.
➤
+
(Hotter) Gradually increase the target temperature
by 0.5 °C.
➤
-
(Colder) Gradually reduce the target temperature
by 0.5 °C.
Display example:
i
The manual change only applies until the
next automatic heating phase becomes active
at the set switching time.
Resetting the manual change
OK
1 sec. Press the OK button on the standard display
for one second to reset the manual change.
The automatic mode with its set heating
phases and target temperatures then applies
again.
The target temperature has been
manually changed.
+
-