Instructions

72
EN
12. Logging on/off manual transmitters and DuoFern HomePilot®
Logging on manual transmitters or DuoFern transmitters:
Both manual transmitters are already logged on to the large button on the garage door drive when in the factory. If you
want to log on another manual transmitter, or have already logged off a manual transmitter that is included in the scope
of supply and want to log it on again, proceed as follows.
NOTE!
After successfully registering you can
operate your garage door drive with
the manual transmitter. You can register
a maximum of 16 additional manual
transmitters.
RolloPort SX5 DuoFern
You can register a maximum of 20 ad-
ditional DuoFern transmitters.
1. Press and hold "S" for 8
seconds.
Logging off manual transmitters or DuoFern
transmitters:
For security reasons, a manual transmitter must
be de-registered in the event of loss, to prevent
the garage door from being operated by unau-
thorised persons.
2. The "0" goes out in the
display.
All manual transmitters are
logged off.
1. Press "S" for approx. 2
seconds and then let go.
2. Two green dots flash
briefly at the bottom
of the display by way of
confirmation.
3. Logging on a manual trans-
mitter.
◆ Press twice the button on the
manual transmitter you want
to use to operate the garage
door drive. A signal tone is
emitted by the drive during
the log-on process by way of
confirmation.
4. Logging on a DuoFern
transmitter or a
HomePilot®.
◆ Switch the DuoFern trans-
mitter orthe HomePilot® to
registering mode.
Login is undertaken automati-
cally.
If registration is successful, the
left-hand dot lights up for ap-
prox. two seconds.
RolloPort SX5 DuoFern
All DuoFern transmitters are
logged off.