Instructions

71
EN
NOTE!
◆ Please note: this concluding step must be
carried out, otherwise the information stored
will be lost.
1. After the reference run,
press "–".
(press several times if
necessary) until "1" is
displayed.
11.10 Conclude programming
2. Keep "P" pressed for
5 seconds.
3. "0" will be displayed
at regular intervals in
order to conclude the
programming and set
the drive into an idle
state.
Method 1: Carry out this method without fail after the reference run.
1. After completing any
setting, press "P" for
5 seconds.
2. "0" will be displayed
at regular intervals in
order to conclude the
programming and set
the drive into an idle
state.
Method 2: After all other settings
The following applies to RolloPort SX5 DuoFern:
The programming must be completed so that you
can make settings in the DuoFern network or on the
HomePilot®.
You can conclude the programming in two ways: