Instructions

68
EN
11.6 Automatic closing time setting
(can also be configured via HomePilot®)
5. Press "+" and select the
required closing time:
6. Press "P" in order to
store the setting.
After a period of time in use, regularly check to
see whether the door is level when opening/
closing, and whether the spring has enough force
to raise the door.
Add a suitable amount of lubricant to all moving
parts regularly.
1. Press "P" for approx.
5 seconds.
11.7 2000 cycle alarm setting
(can also be configured via HomePilot®)
3. Press "P", the display is "0".
(0 = off = factory setting)
4. Press "+", the display
is "1".
(1 = on)
NOTE!
If this function is activated, after 2000 cycles the drive
will indicate with a short whistling tone at regular
intervals that door maintenance must be carried out.
To end the alarm tone
Switch the power off and back on again, or press the
"P" button for 5 seconds.
5. Press "P" in order to save
the setting.
7. Conclude programming
(see page 71 / Method
2) or proceed with next
setting.
6. Conclude programming (see
page 71 / Method 2) or pro-
ceed with next setting.
5 = 150 s
6 = 180 s
7 = 210 s
8 = 240 s
(maximum)
1 = 30 s
2 = 60 s
3 = 90 s
4 = 120 s
2. Press "+"
(if necessary press several
times) until "7" is displayed.