Instructions

67
EN
If the alarm is switched on, the drive beeps if
the door is open for longer than 10 minutes.
The signal tone is emitted for 30 seconds every
10 minutes.
To end the beeping:
Press the door control button to fully close the door.
1. Press "P" for approx.
5 seconds.
11.5 Alarm setting
(can also be configured via HomePilot®)
3. Press "P", the display is "0".
(0 = off = factory setting)
4. Press "+", the display
is "1".
(1 = on = the alarm setting
is switched on)
5. Press "P" in order to
store the alarm setting.
NOTE!
Before the door closes auto-
matically, the drive beeps for 20
seconds. At the same time the
light flashes.
When the door starts closing, the
light shines durably and it beeps
permanently.
After the door has closed, the
drive ends the beeping and the
light remains on for a further 3
minutes.
1. Press "P" for approx.
5 seconds.
11.6 Automatic closing time setting
(can also be configured via HomePilot®)
3. Press "P", the display is
"0".
(0 = off = factory setting)
4. Press "+", the display is "1".
(1 = on = automatic closing
time = 30 seconds).
6. Conclude programming (see
page 71 / Method 2) or pro-
ceed with next setting.
2. Press "+"
(press several times if neces-
sary) until "5" is displayed.
2. Press "+"
(if necessary press several times)
until "6" is displayed.