Instructions

NOTE!

The drive is preset to stage 3 by the supplier. If required

(e. g. if the power level is too low) you can subsequently

adjust the power limiting setting.

If the power level is too low, the door movement

will be impaired, particularly if the mechanical

structure of the door is not well balanced.

1. Press "P" for approx.

5 seconds.

3. Press "P", the display

shows "7" (stage 3).

After resetting of the power level, it is absolutely necessary to repeat the reference run for power limiting

and to conclude the programming again.

◆ Risk of injury if reference run is not undertaken for purposes of power measurement. Also there is a risk

of injury during the reference run process, as the drive develops a high degree of force.

◆ If the subsequent adjustment does not restore correct operation, please contact our authorised Service

department.

5. Press "P", in order

to store the setting.

6. IMPORTANT

Repeat reference run

for power limiting

(refer to page 65).

7. Conclude programming

(refer to page 71 /

method 1).

11.4 Adjust power limiting as required

Power level

Low High

Factory setting

4. Press "+" or press "–" to

select the stage.

2. Press "+".

(if necessary press several

times) until "4" is displayed.