Instructions

65
EN
1. Press "+", the
display shows "3".
2. Press "P",
"3" flashes.
3. The door goes up
automatically.
5. The door goes down.4. After it has stopped,
press the "P" button
twice.
NOTE!
◆ Once you have set the two end points and the reference run for power measure-
ment, you have fulfilled the basic settings required for safe operation.
◆ If you do not require any further settings, you must conclude programming
as specified in Method 1 on page 71, in order to adopt the basic settings
you have just programmed.
◆ After this, you can conclude the following individual settings, either singly or
after all the settings have been programmed, using Method 2 on page 71 .
7. Conclude programming
(refer to page 71 /
method 1).
During the reference run there is a risk of injury,
as the drive develops extremely strong forces.
11.3 Carry out reference run for power measurement
6. After it has stopped, press "P",
to save the information.
"0" will be displayed at regular
intervals in order to conclude the
programming and set the drive in
to an idle state.