Instructions

1. Fit the middle support (13) clip at a suitable

place, as near as possible to the middle point

between the door and the drive head.

Legend

13 = Centre suspension

14 = Hexagon screws (8 x 60 mm)

10.12 (D) Installation of the middle support clip (13)

3. Screw the door bracket (8) tight to the frame

with the enclosed self-tapping hexagon screws

(8 x 15 mm).

4. Finally, ﬁx the door connector (12) to the door

bracket (8) with the enclosed bolt (9).

NOTE!

◆ A straight door connector is supplied pre-mounted, and

this is permanently ﬁxed to the rail.

◆ If you wish to use the bent door connector (12) enclosed

(depending upon your door particular conﬁguration),

you must attach this with two hexagon screws (8 x 20)

to the straight door connector.

5. Finally, secure the bolt (9) by attaching the

securing bolt (11) to prevent it from slipping out.

10.11 (C) Installation of the door bracket (8)