Instructions

53
EN
10. Important assembly instructions
Important instructions for a safe installation.
Follow all installation instructions carefully.
Incorrect installation can lead to serious
injuries.
STOP
During installation there is a risk of injury due
to the unsecured door falling suddenly.
◆ During the installation work, ensure that there are
no persons in the swivelling area of the garage
door.
Before assembly, check...:
◆ ...whether your drive is suitable for the type of
garage door and the garage door height.
◆ ...that the door is in perfect mechanical condition.
The door must be smooth running and be balanc-
ed. Check whether it opens and closes properly.
◆ Open the door approximately 1 m and then let go.
A balanced door should remain in this position.
If not, have your door adjusted by a specialist
company.
◆ The operation of the door must not be hindered by
badly adjusted springs or poorly functioning door
mounts or door constructions.
Faulty installation can result in serious ac-
cidents and injuries.
◆ Fit the actuator for the emergency release at a
height of less than 1.8 metres.
◆ Use only the enclosed mounting materials and only
original spare parts and original accessories.
◆ Any existing door locking devices already fitted to
the door may hinder the correct functioning of the
door and must therefore be removed.
◆ Movable parts of the garage door must not extend
into public footpaths or cycle paths.
◆ Poor lighting hinders the installation work and
can result in injuries. Ensure that there is adequate
lighting during installation work.
◆ It is possible that during the installation work, you
may not be able to open the door for a short period
of time.
◆ This drive is not to be used with doors having open-
ings exceeding 50 mm in diameter or having edges
or protruding parts a person could grip or stand on.
◆ Permanently fix the labels warning against en-
trapment in a prominent place or near any fixed
controllers.
◆ Permanently fix the label concerning the manual
release adjacent to its actuating member.
Before installing the drive...,
◆ ...remove all unnecessary ropes or chains and
switch off any equipment, such as locks, not
needed for powered operation.