Instructions

67
[ 1 ]
[ 8 ]
[ 9 ]
[ 3 ]
[ 6 ]
EN
i
18.5.2 Light sensor connection when using a frame supplied by a third-party manufacturer.
NOTE
◆ If the cable bushing of the operating unit [ 1 ] is covered by
the frame, then it will be necessary to t the additionally
provided spacer frame [ 8 ] onto the rear of the operating
unit [ 1 ].
◆ It may also be necessary to use an intermediate frame [ 9 ]
50 x 50 * (DIN 49075), depending on the respective switch
range used.
* not included