Instructions

23
i
EN
10.
Configure the switching time mode for
the closing time [ ].
◆ NORMAL
◆ ASTRO
◆ OFF
14. Initial commissioning with the help of the installation wizard
NORMAL
At the configured time, an [ Down]-signal will
be sent to the assigned DuoFern actuators.
Example:
The roller shutters close at the configured
closing time.
8.1.
The configured switching time mode will be
sent to all registered DuoFern actuators.
◆ By way of confirmation, for example, the
motors briefly start up and the display
counts all registered actuators.
◆ In the event of a fault (for example, if an
actuator cannot be reached), then the
following message is shown:
9.
Set and confirm the opening time [ ] .
Pre-setting:
This closing time mode applies to the entire
week (MON...SUN) [ MO...SO ].
a)
If [ ASTRO ] is selected, then the calculated
opening time for the current day is displayed.
b)
Configure the switching time mode for the
closing time [ ].
Example: