Instructions

3636
EN
. . .
▲
1 x
2.
1.
3.
1 x
Register DuoFern end devices (applies to item no. 3248 03 66)
In order to be able to operate a DuoFern end device with the DuoFern Standard manual transmitter,
this must be registered with the DuoFern end device concerned.
TIP
Use a thin, not too sharp object to press the connect button.
Switch the desired DuoFern end device or
DuoFern actuator to registering mode.
(see corresponding operating instructions)
The LED’s from all device buttons or group
buttons light up.
NOTE
◆ A fully allocated group button does not light up.
◆ The register mode remains active for 60 seconds.
Switch the DuoFern Standard manual transmitter to
registering mode.
In order to do so, briey press the ”connect” button.
60 seconds