Instructions
Table Of Contents
- Diese Anleitung ...
- Gefahrensymbole
- Verwendet Darstellungen und Symbole
- Sicherheitshinweise
- Bestimmungsgemäße Verwendung
- Gesamtansicht / Bedientasten
- Geräterückseite
- Kurzbeschreibung des DuoFern Handsender Standards
- Erstinbetriebnahme
- Anmelden von DuoFern Endgeräten (für Art.-Nr. 3232 03 64 / 3248 03 66)
- Anmelden von DuoFern Endgeräten (für Art.-Nr. 3248 03 61)
- Abmelden von DuoFern Endgeräten
- Die Funktion „Aufräumen“ aktivieren
- Endpunkteinstellung
- Drehrichtungsumkehr
- Manuelle Bedienung von Aktoren mit mehreren Kanälen
- Steuerung von Jalousien bzw. Dimmern durch Tipp-Betrieb
- Ein- und ausschalten des Tipp-Betriebs
- Automatikfunktion ein- / ausschalten (für Art.-Nr. 3232 03 64)
- Einstellungen löschen (Reset)
- Technische Daten
- Batteriewechsel
- Vereinfachte EU-Konformitätserklärung
- This manual...
- Hazard symbols
- Symbols and depictions used
- Safety instructions
- Intended use
- General view / operating buttons
- Rear side of device
- Brief description of the DuoFern Manual Transmitter Standard
- Initial commissioning
- Logging on DuoFern end units (for item no. 3232 03 64 / 3248 03 66)
- Logging on DuoFern end units (for item no. 3248 03 61)
- Logging off DuoFern end units
- Activating the “Purge” function
- End point setting
- Reversal of rotation direction
- Manual operation of actuators with several channels
- Controlling blinds and dimmers in jog mode
- Switching jog mode on and off
- Switching the automatic function on/off (for item no. 3232 03 64)
- Deleting all settings (reset)
- Technical specifications
- Battery replacement
- Simplified EU declaration of conformity
5555
EN
1.
2.
3 x
+
. . .
. . .
. . .
. . .
approx.
10 s
or
or
i
Controlling blinds and dimmers in jog mode
Function: ◆ If the UP or DOWN button is pressed briefly in jog mode, a jog command is sent. This enables the easy adjustment of Venetian
blind slats as the motor only runs briefly.
◆ When used in combination with dimmers, jog mode increases or decreases the brightness by 10%.
◆ If you press and hold the UP or DOWN button (>1/2 second), the normal UP and DOWN signals are sent. Jog mode can be
switched on and off separately for each group, where applicable.
Switching jog mode on and off
Select the desired group with the corresponding
group button.
Press and hold the STOP button for approx. 10
seconds.
Observe the button LED and status LED:
The LED for the selected group button flashes three times
and the status LED lights up:
Green (Jog mode has been switched on).
Red (Jog mode has been switched off).
Actuators that do not support jog mode ignore jog com-
mands.