Instructions
Table Of Contents
- Diese Anleitung ...
- Gefahrensymbole
- Verwendet Darstellungen und Symbole
- Sicherheitshinweise
- Bestimmungsgemäße Verwendung
- Gesamtansicht / Bedientasten
- Geräterückseite
- Kurzbeschreibung des DuoFern Handsender Standards
- Erstinbetriebnahme
- Anmelden von DuoFern Endgeräten (für Art.-Nr. 3232 03 64 / 3248 03 66)
- Anmelden von DuoFern Endgeräten (für Art.-Nr. 3248 03 61)
- Abmelden von DuoFern Endgeräten
- Die Funktion „Aufräumen“ aktivieren
- Endpunkteinstellung
- Drehrichtungsumkehr
- Manuelle Bedienung von Aktoren mit mehreren Kanälen
- Steuerung von Jalousien bzw. Dimmern durch Tipp-Betrieb
- Ein- und ausschalten des Tipp-Betriebs
- Automatikfunktion ein- / ausschalten (für Art.-Nr. 3232 03 64)
- Einstellungen löschen (Reset)
- Technische Daten
- Batteriewechsel
- Vereinfachte EU-Konformitätserklärung
- This manual...
- Hazard symbols
- Symbols and depictions used
- Safety instructions
- Intended use
- General view / operating buttons
- Rear side of device
- Brief description of the DuoFern Manual Transmitter Standard
- Initial commissioning
- Logging on DuoFern end units (for item no. 3232 03 64 / 3248 03 66)
- Logging on DuoFern end units (for item no. 3248 03 61)
- Logging off DuoFern end units
- Activating the “Purge” function
- End point setting
- Reversal of rotation direction
- Manual operation of actuators with several channels
- Controlling blinds and dimmers in jog mode
- Switching jog mode on and off
- Switching the automatic function on/off (for item no. 3232 03 64)
- Deleting all settings (reset)
- Technical specifications
- Battery replacement
- Simplified EU declaration of conformity
4949
EN
1 x
1.
▲
Activating the “Purge” function
This function logs off all of the logged-on DuoFern end units that no longer react. This could be necessary, for example, with a
faulty device that can no longer be logged off as described above.
Press and hold the “Connect button” for approx.
5 seconds until the status LED flashes red.
The DuoFern Manual Transmitter Standard now sends a
control signal to all logged-on DuoFern end units. The
devices that do not confirm the signal are automatically
deleted.
Observe the status LED
Flashing red: Purge mode is still active.
Green: The purge was successful.