Instructions
Table Of Contents
- Diese Anleitung ...
- Gefahrensymbole
- Verwendet Darstellungen und Symbole
- Sicherheitshinweise
- Bestimmungsgemäße Verwendung
- Gesamtansicht / Bedientasten
- Geräterückseite
- Kurzbeschreibung des DuoFern Handsender Standards
- Erstinbetriebnahme
- Anmelden von DuoFern Endgeräten (für Art.-Nr. 3232 03 64 / 3248 03 66)
- Anmelden von DuoFern Endgeräten (für Art.-Nr. 3248 03 61)
- Abmelden von DuoFern Endgeräten
- Die Funktion „Aufräumen“ aktivieren
- Endpunkteinstellung
- Drehrichtungsumkehr
- Manuelle Bedienung von Aktoren mit mehreren Kanälen
- Steuerung von Jalousien bzw. Dimmern durch Tipp-Betrieb
- Ein- und ausschalten des Tipp-Betriebs
- Automatikfunktion ein- / ausschalten (für Art.-Nr. 3232 03 64)
- Einstellungen löschen (Reset)
- Technische Daten
- Batteriewechsel
- Vereinfachte EU-Konformitätserklärung
- This manual...
- Hazard symbols
- Symbols and depictions used
- Safety instructions
- Intended use
- General view / operating buttons
- Rear side of device
- Brief description of the DuoFern Manual Transmitter Standard
- Initial commissioning
- Logging on DuoFern end units (for item no. 3232 03 64 / 3248 03 66)
- Logging on DuoFern end units (for item no. 3248 03 61)
- Logging off DuoFern end units
- Activating the “Purge” function
- End point setting
- Reversal of rotation direction
- Manual operation of actuators with several channels
- Controlling blinds and dimmers in jog mode
- Switching jog mode on and off
- Switching the automatic function on/off (for item no. 3232 03 64)
- Deleting all settings (reset)
- Technical specifications
- Battery replacement
- Simplified EU declaration of conformity
4747
EN
▲
2.
1.
3.
4.
1 x
Observe the status LED
Green: Log-on was successful.
Red: The button is already fully allocated
Logging on DuoFern end units (for item no. 3248 03 61)
Switch the desired DuoFern end unit or DuoFern
actuator to log-on mode.
(See the corresponding operating manual)
Switch the DuoFern Manual Transmitter Standard
to log-on mode.
In order to do so, briefly press the “Connect button”.
Points 1 and 2 must be repeated for every actuator.