Instructions
Table Of Contents
- Diese Anleitung ...
- Gefahrensymbole
- Verwendet Darstellungen und Symbole
- Sicherheitshinweise
- Bestimmungsgemäße Verwendung
- Gesamtansicht / Bedientasten
- Geräterückseite
- Kurzbeschreibung des DuoFern Handsender Standards
- Erstinbetriebnahme
- Anmelden von DuoFern Endgeräten (für Art.-Nr. 3232 03 64 / 3248 03 66)
- Anmelden von DuoFern Endgeräten (für Art.-Nr. 3248 03 61)
- Abmelden von DuoFern Endgeräten
- Die Funktion „Aufräumen“ aktivieren
- Endpunkteinstellung
- Drehrichtungsumkehr
- Manuelle Bedienung von Aktoren mit mehreren Kanälen
- Steuerung von Jalousien bzw. Dimmern durch Tipp-Betrieb
- Ein- und ausschalten des Tipp-Betriebs
- Automatikfunktion ein- / ausschalten (für Art.-Nr. 3232 03 64)
- Einstellungen löschen (Reset)
- Technische Daten
- Batteriewechsel
- Vereinfachte EU-Konformitätserklärung
- This manual...
- Hazard symbols
- Symbols and depictions used
- Safety instructions
- Intended use
- General view / operating buttons
- Rear side of device
- Brief description of the DuoFern Manual Transmitter Standard
- Initial commissioning
- Logging on DuoFern end units (for item no. 3232 03 64 / 3248 03 66)
- Logging on DuoFern end units (for item no. 3248 03 61)
- Logging off DuoFern end units
- Activating the “Purge” function
- End point setting
- Reversal of rotation direction
- Manual operation of actuators with several channels
- Controlling blinds and dimmers in jog mode
- Switching jog mode on and off
- Switching the automatic function on/off (for item no. 3232 03 64)
- Deleting all settings (reset)
- Technical specifications
- Battery replacement
- Simplified EU declaration of conformity
42
EN
Connect button
You can perform the following functions with the "Connect” button:
◆ Log-on mode Log DuoFern end units on to the manual transmitter.
◆ Reversal of rotation direction Change the rotation direction of the tubular motor or switch between the device and
lighting function.
◆ Purge Delete the connection between the manual transmitter and actuators that are no longer
available.
Disconnect button
You can perform the following functions with the "Disconnect” button:
◆ Log-off mode Log DuoFern end units off from the manual transmitter.
◆ End point setting Set the end points of electronic RADEMACHER tubular motors.
◆ Reset Reset to the factory settings.
Status LED
The bi-coloured status LED (red/green) shows whether the DuoFern end units have received and confirmed the control signal.
Brief description of the DuoFern Manual Transmitter Standard
i