Instructions
Table Of Contents
- 1. This manual...
- 1.1 How to use this manual
- 2. Hazard symbols
- 2.1 Symbols and depictions used
- 3. Safety instructions
- 3.1 Intended use
- 4. Included in delivery
- 5. General view
- 5.1 Operating buttons
- 5.2 Display and its symbols
- 6. Product description
- 7. Technical specifications
- 8. Installation
- 8.1 Installation sequence
- 9. Menu overview
- 10. Menu 1 - Configuring the sun function
- 11. Menu 2 - Configuring the wind function
- 12. Menu 8 - Service functions
- 12.1 Menu 8.1 - Sun test function
- 12.2 Menu 8.1 - Wind test function
- 12.3 Menu 8.2 - Rotation direction test / change of rotation direction
- 12.4 Menu 8.3 - Checking the battery status
- 12.5 Menu 8.0 - Viewing the software version
- 13. Menu 9 - Logging DuoFern devices on/off
- 13.1 Logging on devices
- 13.2 Logging off devices
- 13.3 Clear-up
- 13.4 Deleting all DuoFern devices
- 14. Reset (factory settings)
- 15. Cleaning and care
- 16. Simplified EU declaration of conformity
15
EN
8.1 Installation sequence
1. Remove the protective caps from
the wall bracket.
2. Loosen the fulcrum screw slightly
and push down on the sensor
housing.
3. Mark the drill holes and drill the
holes with an 8 mm drill bit.
8 mm
4. Install the DuoFern Sun/Wind
Sensor with the wall plugs and
screws provided.
5. Then align the sensor housing
horizontally and secure it with the
fulcrum screw.
◆ The solar cell must point
upwards.
◆ The wind propeller must point
downwards.
6. Finally, push the protective caps
onto the wall bracket.
Align horizontally
i