Instructions
Table Of Contents
- 1. This manual...
- 2. Hazard symbols
- 2.1 Symbols and depictions used
- 2.2 Glossary - definition
- 3. Included in delivery
- 4. General view / operating elements
- 5. Product description
- 6. Technical specifications
- 7. Safety instructions
- 7.1 Intended use
- 8. Inserting / changing the battery
- 9. Installation
- 9.1 Installation instructions
- 9.2 Installation examples
- 9.3 Temporary installation
- 9.4 Teaching in the window or door positions
- 9.5 Check the taught-in positions
- 9.6 Final installation of the DuoFern Window/Door Contact
- 10. DuoFern devices (logging on / logging off / clearing)
- 10.1 Logging on DuoFern devices
- 10.2 Logging off DuoFern devices
- 10.3 Clearing the DuoFern network
- 11. Logging on to the HomePilot®
- 12. Deleting all settings
- 13. Closing the housing cover
- 14. Cleaning / maintenance
- 15. Simplified EU declaration of conformity
- 16. Information about environmental protection
- 17. Warranty terms and conditions
21
EN
9.6 Final installation of the
DuoFern Window/Door Contact
i
1. Mark the installation positions of the sensor part and mag-
net, e.g. with a pencil.
2. Detach the xed sensor part and magnet.
3. Remove the round adhesive pads and clean the adhesive
points thoroughly with the cleaning cloth provided.
4. Apply the double-sided adhesive strips.
5. Re-ax the sensor part and magnet precisely to the previ-
ously marked points with light pressure.
i
Repeat the teach-in process if necessary (see
page 19), if the respective states are no longer
detected properly after the nal installation.