Instructions
Table Of Contents
- 1. This manual...
- 2. Hazard symbols
- 2.1 Symbols and depictions used
- 2.2 Glossary - definition
- 3. Included in delivery
- 4. General view / operating elements
- 5. Product description
- 6. Technical specifications
- 7. Safety instructions
- 7.1 Intended use
- 8. Inserting / changing the battery
- 9. Installation
- 9.1 Installation instructions
- 9.2 Installation examples
- 9.3 Temporary installation
- 9.4 Teaching in the window or door positions
- 9.5 Check the taught-in positions
- 9.6 Final installation of the DuoFern Window/Door Contact
- 10. DuoFern devices (logging on / logging off / clearing)
- 10.1 Logging on DuoFern devices
- 10.2 Logging off DuoFern devices
- 10.3 Clearing the DuoFern network
- 11. Logging on to the HomePilot®
- 12. Deleting all settings
- 13. Closing the housing cover
- 14. Cleaning / maintenance
- 15. Simplified EU declaration of conformity
- 16. Information about environmental protection
- 17. Warranty terms and conditions
20
EN
9.5 Check the taught-in positions
i
5 minutes You can check the stored window and
door positions for ve minutes after
the teach-in process.
1. Open, tilt and close the window or door with the xed
DuoFern Window/Door Contact.
Each detected position is acknowledged by acoustic
signals:
1 x = Open
2 x = Tilted
3 x = Closed
i
The DuoFern Window/Door Contact is ready for
operation if the teach-in process has been fully
completed.
i
If the installation position of the window or door
changes over time and the teach-in positions
therefore no longer lead to the desired control
commands, you may need to carry out a new
teach-in process.