Instructions
Table Of Contents
- 1. This manual...
- 2. Hazard symbols
- 2.1 Symbols and depictions used
- 2.2 Glossary - definition
- 3. Included in delivery
- 4. General view / operating elements
- 5. Product description
- 6. Technical specifications
- 7. Safety instructions
- 7.1 Intended use
- 8. Inserting / changing the battery
- 9. Installation
- 9.1 Installation instructions
- 9.2 Installation examples
- 9.3 Temporary installation
- 9.4 Teaching in the window or door positions
- 9.5 Check the taught-in positions
- 9.6 Final installation of the DuoFern Window/Door Contact
- 10. DuoFern devices (logging on / logging off / clearing)
- 10.1 Logging on DuoFern devices
- 10.2 Logging off DuoFern devices
- 10.3 Clearing the DuoFern network
- 11. Logging on to the HomePilot®
- 12. Deleting all settings
- 13. Closing the housing cover
- 14. Cleaning / maintenance
- 15. Simplified EU declaration of conformity
- 16. Information about environmental protection
- 17. Warranty terms and conditions
18
EN
i
9.4 Teaching in the window or door positions
The DuoFern Window/Door Contact has three operating
modes. The teach-in processes are carried out in the re-
spective mode:
◆ Window mode (open / closed / tilted), LED ashes green
◆ Door mode (open / closed), LED ashes blue
◆ Inverted door mode (open = closed / closed = open),
LED ashes red
i
Start each teach-in process with the window or
door open. This is also required each time the
operating mode is changed.
Time limit for the teach-in process
The teach-in process is active for 60 seconds after
activating a mode.
Cancelling the teach-in process
S
You can cancel the teach-in process
by pressing the set button.
Pay attention to the acoustic feedback signal
An acoustic feedback signal is given during the teach-in
process. If an acoustic feedback signal is not given, this
is an indication that the distance between the magnet and
sensor was too large or ferrous material or other magnets
do not enable a reliable dierentiation between the states.