User's Manual

NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device
must accept
any interference received, including interference that may
cause undesired operation.
RF Exposure Information:
FCC RF Exposure requirements: The highest SAR value reported
under this standard during product certification for use next to the
body with the minimum separation distance of 0mm is 0.03 W/Kg.
This transmitter must not be collocated or operating in conjunction
with any other antenna or transmitter.
This product is compliance to FCC RF Exposure requirements
and refers to FCC website https://apps.fcc.gov/oetcf/eas/reports/
GenericSearch.cfm search for FCC ID: 2AS98T1
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions: (1)
this device may not cause interference, and(2) this device must accept
any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables auxappareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes :(1) l’appareil ne doit pas
produire de brouillage, et(2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible
d’en compromettre lefonctionnement.
This EUT is compliance with SAR for general population/uncontrolled
exposure limits in IC RSS-102 and had been tested in accordance
with the measurement
methods and procedures specified in IEEE
1528 and IEC 62209. This equipment should be installed and operated
with minimum distance 0 mm between the radiator and your body.
This device and its antenna(s)must not be co-located or operating in
conjunction with any other antenna or transmitter.
Cet appareil est conforme aux limites d’exposition DAS incontrôlée
pour la population générale de la norme CNR-102 d’Industrie
Canada et a été testé en conformité avec les méthodes de mesure
et procédures spécifiées dans IEEE 1528 et IEC 62209. Cet appareil
doit être installé et utilisé avec une distance minimale de 0 mm entre
i’émetteur et votre corps. Cet appareil et sa ou ses antennes ne
doivent pas être co-localisés ou fonctionner en conjonction avec tout
autre antenne ou transmetteur.
T1-Quicktart-20190617a.indd 3 2019-06-17 12:04
3