User manual

Digital B-RAD USER MANUAL
New World Technologies Inc. Page • 7
V2014.07.03
Figure 2.3.2-1: RAD Li-Ion Battery Pack
2.4 RAD Battery Charger
CAUTION! The RAD Li-Ion Battery Pack should only be charged on the RAD Battery Charger. If an
incompatible charger is used, damage to the RAD Battery will occur.
The Charging Status Display (Figure 2.4-1) on the RAD Battery Charger is used to notify the
operator when the RAD Battery is charging, when the charge is complete and if there is an
error.
Figure 2.4-1: Charging Status Display
2.4.1 Charging the RAD Li-Ion Battery Pack
Note: The temperature range for charging is 0˚C to 50˚C (32 ̊ F to 122 ̊ F).
To charge the RAD Battery:
1. Plug the RAD Battery Charger into the wall outlet.
Result: The Red Warning Light will turn on for one second and then the Green Status Light
will turn on for one second.
2. Align the RAD Battery with the RAD Battery Charger.
3. Slide the RAD Battery into place.
Result: The Green Status Light will flash while the RAD Battery is charging.
When the RAD Battery has been fully charged, the Green Status Light will stop flashing and
stay illuminated. Until the RAD Battery is removed from the RAD Charger, it will convert to
conservation mode which will maintain the battery charge at maximum capacity.
To remove the RAD Battery:
1. Slide the RAD Battery away from the RAD Charger.
2. Check that the RAD Battery is fully charged (refer to Section 2.3.2 – Checking RAD
Battery Charge).
Green Status
Light
Red Warning
Light
“Charge” Button