User manual

Digital B-RAD USER MANUAL

New World Technologies Inc. Page • 24

V2014.07.03

Figure 4.2-1: Passed Torque Cycle

Figure 4.2-2: Failed Torque Cycle

Note: The result will be displayed for ten seconds or until the Digital B-RAD is reversed or a new cycle

is started.

5.0 Errors

Important! Disassembling or attempting repair will void warranty.

In case of an error, the following messages may appear:

STALL – High torque at start up

HI CURR – High current during wind-up

NO CURR – No current during wind-up

LO BATT – Low battery voltage during wind-up

Solution:

1. Ensure RAD Li-Ion Battery Pack is fully charged. If not, charge the RAD Battery

and re-try. If fully charged, continue with solution.

2. Contact New World Technologies Inc. Technical Support (refer to Section 6.0 –