User manual

Digital B-RAD USER MANUAL
New World Technologies Inc. Page • 23
V2014.07.03
CORRECT: Reaction Arm is reacting off the middle of the Reaction Arm’s foot.
Figure 4.1.4-1: Correct Reaction Point
INCORRECT: Reaction Arm is reacting off the heel of the Reaction Arm. This can cause
premature tool failure.
Figure 4.1.4-2: Incorrect Reaction Point
4.2 Torque Operation
To operate the Torque Cycle:
1. Modify the Target Torque to the desired torque. Refer to Section 3.3.7 – Change
the Target Torque if the Digital B-Rad is not in the Locked Level or Section 3.3.1 –
Select a Preset if it is in the Locked Level.
Note: Refer to Section 1.2.1 – Torque Ranges.
2. Place the Digital B-RAD on the joint system.
3. Ensure the Forward/Reverse Switch is in the Forward Position.
4. Press and hold the On/Off Trigger.
Note: To stop the Torque Cycle at any time, release the On/Off Trigger. This will result in a
Failed Cycle.
When the Torque Cycle is passed, the clutch mechanism will slip. Immediately release the
On/Off Trigger.
CAUTION! Damage will occur if the clutch is allowed to slip for an extended period of time.
Result: The Target Torque and “Pass” (Figure 4.2-1) or “Fail” (Figure 4.2-2) will be displayed on the
Main screen.