User manual

Digital B-RAD USER MANUAL
New World Technologies Inc. Page • 12
V2014.07.03
3.3.2 Hard Joint Mode
CAUTION! Damage to the Digital B-RAD and the joint may occur if the Joint Rate is less than 10 ̊ and
Hard Joint Mode is not enabled.
The Digital B-RAD is calibrated for a Joint Rate greater than 10 ̊. The Hard Joint Mode
allows the Digital B-RAD to operate on a joint with a Joint Rate of less than 10 ̊.
To enable/disable Hard Joint Mode:
1. Press the “Centre” button.
Result: The Main Menu screen will be displayed (Figure 3.3.2-1).
2. Use the “Up Arrow” button and the “Down Arrow” button to highlight the “Hard
Joint” option.
3. Press the “Centre” button to select the “Hard Joint” option.
Result: The LCD Display will return to the Main screen with Hard Joint displayed (Figure
3.3.2-2).
Figure 3.3.2-1: Main Menu Screen
Figure 3.3.2-2: Main Screen – Hard Joint Mode
3.3.3 View Tool Information
This function allows the operator to view the Digital B-RAD information including:
- Date and Time
- Software Version
- Digital B-RAD Model
- Serial Number
- Current Units
- Voltage
- Minimum Torque
- Maximum Torque
To view the Tool Information:
1. Press the “Centre” button.
Result: The Main Menu screen will be displayed (Figure 3.3.3-1).
2. Use the “Up Arrow” button and the “Down Arrow” button to highlight the “Info”
option.
3. Press the “Centre” button to select the “Info” option.
Result: The Info Menu screen will be displayed (Figure 3.3.3-2). The “Tool Info” option will
already be highlighted.
4. Press the “Centre” button to select the “Tool Info” option.
Result: The Tool Information screen will be displayed (Figure 3.3.3-3).