Specifications

Installation and Operation Manual Chapter 5 Configuring Typical Applications
ASMi-54 Ver. 1.0 Configuring the Bridge 5-3
4. In the Trap field, specify Mask or Unmask to mask or unmask traps for the
new management station.
5. Select Save.
6. Repeat the previous steps for each network manager you wish to add.
 To update existing manager parameters:
1. From the Management menu (Main>Configuration>System>Management),
select Manager List to open the Manager List menu.
2. Move the cursor to the Manager IP cell you wish to modify by pressing <Tab>.
The selected cell is highlighted and the value is displayed in the “Change cell”
field.
3. Press <1>, and then press <Enter> to enter a new IP address for the selected
network manager.
4. Move the cursor to the Trap field and toggle between Mask and Unmask to
mask or unmask traps for the selected management station.
5. Repeat the previous steps for each manager you wish to update.
6. Press <ESC> to return to the Management menu.
5.3 Configuring SHDSL Physical Layer
Defines the characteristics of the physical SHDSL ports.
 To configure the SHDSL physical layer:
1. Open the SHDSL Physical Layer menu (Main>Configuration>Physical
layer>SHDSL).
The system automatically opens the appropriate menu.
2. Leave the parameters at their default settings in one device and change the
clock source of the other device to RX Clock: STU-R.
3. To define the parameters for each SHDSL physical port, see
Configuring Ports
at the Physical Level
for more information.
4. Press <ESC> to return to the Physical Layer menu.
5. Press <ESC> to return to the Configuration menu.
5.4 Configuring the Bridge
This part of the application configuration procedure has four major stages:
• Defining the bridge.
• Defining VLANS and adding them the relevant bridge ports.
• Configuring the SHDSL physical layer.