Specifications

Chapter 4 Configuration Installation and Operation Manual
4-14 Configuring for Operation ASMi-54 Ver. 1.0
ASMi-54
Main Menu > Configuration > Physical Layer > SHDSL > PME
Configuration
PME (Physical Medium Entity) (1)
1. Administrative Status (Up)
2. Line Probe (Disable)
3. Line Rate (192000)
4. Current Margin > (0)
5. Worst Margin > (0)
6. Loop Attenuation Threshold (dB)[0…127] (0)
7. SNR Margin Threshold (dB)[0…15] (0)
>
F-Forward
ESC-Previous menu; !-Main menu; &-Exit
Figure 4-17. SHDSL PME Port Configuration Screen
Table 4-4. SHDSL PME Port Configuration Parameters
Parameter Possible Values Remarks
PME (Physical
Medium Entity)
1 – 4 Index of the SHDSL PME.
Default: 1
Administrative
Status
Up
Down
Administrative status of the SHDSL PME.
Default: Up
Line Probe Disable
Enable
Enable/disable support for Line Probe of the units in an SHDSL span.
Default: Disable
Line Rate 192000-
5696000 bps
The transmission rate for the associated SHDSL PME in bits-per-
second (bps) and includes both payload (user data) and any
applicable framing overhead.
Default: 192000
Current Margin -10…0…21 The downstream/upstream current condition target SNR margin in
dB. To configure the current margin, see Configuring the SHDSL PME
Current Margin
.
Default: 0 (Disable)
Note: Appears only when Line Probe is “Enable”.
Worst Margin -10…0…21 The downstream/upstream worst case target SNR margin in dB. To
configure the worst margin, see
Configuring the SHDSL PME Worst
Margin
.
Default: 0 (Disable)
Note: Appears only when Line Probe is “Enable”.
Loop
Attenuation
Threshold (dB)
0…127 The loop attenuation alarm threshold.
Default: 0