Specifications

ASMi-54 Ver. 1.0 Configuring ASMi-54 1
Quick Start Guide
The ASMi-54 should be installed by an experienced technician only. If you are
familiar with the ASMi-54, use this guide to prepare the unit for operation.
1. Installing ASMi-54
Connecting the Interfaces
 To connect the interfaces:
1. Connect the user LAN to the RJ-45 connector designated 10/100BaseT (up to
four connectors).
2. Connect the control terminal to the front panel CONTROL connector.
or
Connect a Telnet host, a PC running a Web browsing application
(ConfiguRAD), or an SNMP management station to the Ethernet port.
Connecting the Power
 To connect the power:
• Connect the power cable to the power socket on the ASMi-54 rear panel and
the other end to the power outlet.
The unit has no power switch. Operation starts when the power is applied to
the power connector.
2. Configuring ASMi-54
Configure ASMi-54 to the desired operation mode via an ASCII terminal connected
to the rear panel CONTROL port. After configuring, you can manage the unit over
Telnet, a PC running a Web browsing application (ConfiguRAD) or SNMP via the
Ethernet port or inband.
Remote management requires the configuration of an IP address (see Chapter 4 ).
Note