Specifications

ASMi-54C LRS-102 Ver. 2.0 1
Quick Start Guide
If you are familiar with the ASMi-54C modules, use this guide to prepare it for
operation.
Preparations for Operation
SFPs installed on ASMi-54C modules may be equipped with a laser diode. In such
cases, a label with the laser class and other warnings as applicable will be
attached near the optical transmitter. The laser warning symbol may be also
attached.
For your safety:
• Before turning on the equipment, make sure that the fiber optic cable is intact
and is connected to the optical transmitter.
• Do not use broken or unterminated fiber-optic cables/connectors.
• Do not look straight at the laser beam, and do not directly into the optical
connectors while the unit is operating.
• Do not attempt to adjust the laser drive current.
• The use of optical instruments with this product will increase eye hazard.
Laser power up to 1 mW could be collected by an optical instrument.
• Use of controls or adjustment or performing procedures other than those
specified herein may result in hazardous radiation exposure.
ATTENTION: The laser beam may be invisible!
1. If necessary, install the prescribed SFPs in the ASMi-54C SFP sockets.
2. Insert the module in the assigned I/O slot.
3. Refer to the site installation plan, identify the cables intended for connection
to the ASMi-54C connectors, and connect the cables as explained below.
³ To connect cables to SHDSL ports:
1. Connect the 26-pin connector of the CBL-DB26-8SHDSL cable to the module
SHDSL.bis front panel SHDSL.bis connector.
2. Connect the RJ-45 plug of each line (the plugs are marked CH-1 to CH-8) to
the prescribed user’s equipment or patch panel connector. Insulate unused
connectors, to prevent accidental short-circuiting of their exposed contacts
to metallic surfaces.
³ To connect cables to the optical Ethernet ports:
1. Connect each prescribed cable to the corresponding ASMi-54C connector,
ETH1 or ETH2. When two fibers are used, pay attention to connector polarity:
the transmitter output is at left-hand side.
Warning