Specifications

Installation and Operation Manual Chapter 3 Configuration
ASMi-54C LRS-102 Ver. 2.0 Configuring Physical Layer Parameters of SHDSL Lines 3-11
³ To configure the PCS parameters:
1. Navigate to the Configuration > Physical layer > I/O screen, and then select
the I/O slot of the desired ASMi-54C module.
2. Select the SHDSL option.
3. Select the PCS option.
You will see the configuration screen for the first PCS (the PCS with the
lowest index number). Scroll using F and B to reach the desired PCS, or
use the PCS field to enter manually the desired port number, in the range
of 1 to 8.
Table 3-5 lists the ASMi-54C PCS parameters.
Table 3-5. ASMi-54C PCS Parameters
Parameter Function Values
Slot Identifies the I/O slot and module
types on which the PCS is
supported
I/O-1 to I/O-12, followed by the ASMi-54C card type
designation
Rate Displays the PCS payload rate, in
kbps.
The displayed value is automatically
adjusted to the selected Lines, Wire
Pair and Payload Rate values.
This parameter is not displayed
when Line Probe is ENABLE
The range is 192 to 22784 kbps
Wire Pair When the PCS is associated with a
line using the multiple wire mode
(available only when TC Layer is
HDLC), displays the master line and
the list of other lines, as
determined by means of the Wires
parameter (see
Table 3-2 )
The lines are displayed in the format Master line.Line,
with commas as separators.
For example, when the master line is 1 and the Wires
parameter is 8-Wires, the list is 1.1, 1.2, 1.3, 1.4
PCS Selects the PCS to be configured The available selections are 1 to 8, subject to
restrictions given in
Table 3-4 .
Default: 1
Administrative
Status
Used to enable/disable the flow of
traffic through the selected PCS
UP — The flow of traffic is enabled.
DOWN — The flow of traffic is disabled. This state
should be selected as long as the PCS configuration has
not yet been completed, or when it is necessary to
stop traffic flow through the PCS.
Default: DOWN
Name Used to enter a logical name for
the selected PCS
Up to 25 alphanumeric characters.
Default: Empty string