Specifications

Chapter 3 Configuration Installation and Operation Manual
3-6 Configuring Physical Layer Parameters of SHDSL Lines ASMi-54C LRS-102 Ver. 2.0
Table 3-2. ASMi-54C SHDSL Physical Port Parameters
Parameter Function Values
Rate Displays the total SHDSL line rate,
which includes the overhead and the
payload rate.
The displayed value is automatically
adjusted to the selected Wires and
Payload Rate values.
This parameter is not displayed when
Line Probe is ENABLE. Note that at the
REMOTE side, the line probing must
always be enabled, and therefore it is
not possible to select a specific rate
The range is 200 to 22816 kbps
Line Selects the index number of the SHDSL
line to be configured.
When using multiple lines (selected by
means of the Wires parameter), only
lines that can be independently
configured are displayed: the index
numbers of lines that are grouped
together are automatically skipped.
See details in
Table 3-3
The range of SHDSL lines index numbers is 1 to 8. In
addition, it is also possible to select All Lines.
Default: 1
Administrative
Status
Used to enable/disable the selected
SHDSL port (line)
UP – The selected line is enabled.
DOWN – The selected line is disabled. This state
should be selected as long as the line configuration
has not yet been completed, or when it is necessary
to stop traffic flow through the line.
Default: DOWN
Name Used to enter a logical name for the
selected line
Up to 25 alphanumeric characters.
Default: Empty string
Wires Selects the number of lines (wire pairs)
bonded together to.
The available selections depend on the
TC Layer parameter
2 Wires – Each port operates independently. In this
The number of the line is identical to the number of
the physical SHDSL port in the ASMi-54C SHDSL.bus
connector to which the line is connected.
4 Wires – Two ports (with sequential index
numbers) are bonded together. See
Table 3-3 for
details regarding the ports that support this option.
This selection is available only when TC Layer is
HDLC.
8 Wires – Four ports (with sequential index
numbers) are bonded together. See
Table 3-3 for
details regarding the ports that support this option.
This selection is available only when TC Layer is
HDLC.
Default: 2 Wires