Specifications
Installation and Operation Manual Chapter 3 Configuration
ASMi-54C LRS-102 Ver. 2.0 ASMi-54C Configuration Sequence 3-3
ASMi-54C configuration includes the following main types of tasks:
• Tasks needed to configure an ASMi-54C module and put it into service. These
tasks include the programming of ASMi-54C modules not yet installed in
LRS-102 database, and configuring the parameters of the desired module
SHDSL ports (lines) and PCSs.
• Tasks related to the utilization of the module TDM ports (TDM services).
• Tasks related to the utilization of the module Ethernet ports, and the
provisioning of Ethernet services.
The recommended configuration sequence for each type of task is described
below, together with references to the supervision terminal screens used to
perform each task.
³ To configure an ASMi-54C module and put it into service (see
Section
3.4
):
1. If necessary, program (add) an ASMi-54C module not yet installed in the
LRS-102 chassis to the database.
For the supervision terminal, use Configuration > System > Card Type.
³ To configure the SHDSL physical layer parameters (see
Section
3.5
):
1. Configure the physical layer parameters for the active SHDSL ports (lines) of
the ASMi-54C module.
For the supervision terminal, use Configuration > Physical Layer > I/O > SHDSL
> Lines.
2. Configure the physical layer parameters for the active PCSs of the ASMi-54C
module.
For the supervision terminal, use Configuration > Physical layer > I/O> SHDSL
> PCS.
³ To configure the Ethernet physical layer parameters (see
Section
3.6
):
• Configure the physical layer parameters for the Ethernet ports of the
ASMi-54C module.
For the supervision terminal, use Configuration > Physical Layer > I/O >
Ethernet.
³ To configure Ethernet services supported by the module bridge ports (see
Section
3.7
):
• Configure each Ethernet services flow that is terminated at a PCS or Ethernet
port defined on the ASMi-54C being configured, and map the other end to
the prescribed bridge port.
For the supervision terminal, use Configuration > Applications > Ethernet
Services > Flows (for instructions, refer to the
LRS-102 Installation and
Operation Manual
).