Specifications

Chapter 2 Installation and Setup Installation and Operation Manual
2-4 Connecting to ASMi-54C Modules ASMi-54C LRS-102 Ver. 2.0
Module Installation Procedure
The ASMi-54C module starts operating as soon as it is inserted in an operating
chassis.
³ To install an ASMi-54C module:
1. Refer to the system installation plan and identify the prescribed module slot.
2. Check that the fastening screws at the module sides are free to move.
3. Insert the ASMi-54C module in its chassis slot and slide it backward as far as
it goes.
4. Secure the ASMi-54C module by tightening its two fastening screws.
5. The module starts operating as soon as it is plugged into an operating
enclosure. At this stage, ignore the alarm indications.
2.2 Connecting to ASMi-54C Modules
Before starting, identify the cables intended for connection to each port of this
module, in accordance with the site installation plan.
Connecting to Electrical Ethernet Ports
³ To connect cables to the ASMi-54C electrical Ethernet ports:
1. Connect the prescribed cable to the corresponding connector, ETH1 or ETH2.
Connecting to Optical Ethernet Ports
Before starting, review the general optical cable handling instructions section in
Chapter 2 of the LRS-102 Installation and Operation Manual .
³ To connect cables to the optical Ethernet ports:
1. Connect each prescribed cable to the corresponding ASMi-54C connector,
ETH1 or ETH2.
When two fibers are used, pay attention to connector polarity: the
transmitter output is at left-hand side.
Connecting Cables to SHDSL Ports
Using the site installation plan, identify the cable intended for connection to the
ASMi-54C SHDSL.bis connector, and connect the cable to the module connector
as explained below.
Warning